| Address mark not found |
Faulty CD/diskette drive subsystem or hard-drive subsystem; faulty system board. |
| Alert! Current configuration does not support redundant memory. Redundant memory is disabled. |
Memory modules installed are not the same type and size in all banks; faulty memory module(s). |
| Alert! Unsupported memory or incomplete sets in the following bank(s): Bank x |
Memory modules installed in the specified bank are not the same type and size; faulty memory module(s). |
| Amount of available memory limited to 256 MB! |
OS Install Mode is enabled in the System Setup program. |
| Auxiliary device failure |
Loose or improperly connected mouse or keyboard cable; faulty mouse or keyboard. |
| BIOS Update Attempt Failed! |
Remote BIOS update attempt failed. |
| CD drive not found |
Improperly connected or missing CD drive. |
| CPUs with different cache sizes detected |
Microprocessors with different cache sizes are installed. |
| Decreasing available memory |
Faulty or improperly installed memory modules. |
| Diskette drive n seek failure |
Incorrect configuration settings in the System Setup program. |
| Faulty or improperly installed diskette drive. |
| Diskette read failure |
Faulty or improperly inserted diskette. |
| Diskette subsystem reset failed |
Faulty or improperly installed diskette drive. |
| ECC memory error |
Faulty or improperly installed memory modules. |
| Remote access controller error |
Embedded remote access memory may be temporarily corrupted. |
| Remote access controller is not present |
| Error: Maximum PCI option ROM count exceeded! |
Too many expansion cards have ROM enabled in the System Setup program. |
| Gate A20 failure |
Faulty keyboard controller; faulty system board. |
| Hard disk controller failure |
Incorrect configuration settings in System Setup program; improperly installed hard drive, or loose interface or power cable; faulty hard-drive controller subsystem. |
| Hard disk read failure |
| I/O parity interrupt at address |
Faulty or improperly installed expansion card. |
| Invalid configuration information - please run SETUP program |
Incorrect configuration settings in System Setup program; NVRAM_CLR jumper is installed; faulty system battery. |
| Invalid NVRAM configuration, resource re-allocated |
System configuration data has been ignored. |
| Invalid SCSI configuration SCSI cable detected on connector SCSI B of the SCSI backplane, daughter board not present |
A SCSI cable is connected to the channel B connector on the SCSI backplane board; SCSI backplane daughter board is not installed. |
| Keyboard controller failure |
Faulty keyboard controller; faulty system board. |
| Keyboard clock line failure |
Loose or improperly connected keyboard cable; faulty keyboard; faulty keyboard controller. |
| Keyboard data line failure |
| Keyboard failure |
| Keyboard stuck key failure |
| Memory address line failure at address, read value expecting value |
Faulty or improperly installed memory modules. |
| Memory double word logic failure at address, read value expecting value |
| Memory high address line failure at start address to end address |
| Memory high data line failure at start address to end address |
| Memory odd/even logic failure at start address to end address |
| Memory write/read failure at address, read value expecting value |
| Memory parity failure at start address to end address |
Faulty or improperly installed memory modules. |
| Memory parity error at address |
| No boot device available |
Faulty or missing CD/diskette drive subsystem, hard drive, or hard-drive subsystem. |
| No boot sector on hard-disk |
No operating system on hard drive. |
| No PXE-capable device available |
<F12> pressed during POST and no PXE devices are detected. |
| No timer tick interrupt |
Faulty system board. |
| Not a boot diskette |
No operating system on diskette. |
| PCI BIOS failed to install |
Loose cables to expansion card(s); faulty or improperly installed expansion card. |
| Plug and Play Configuration Error Embedded xxx |
Error encountered in initializing PCI device; faulty system board. |
| Plug and Play Configuration Error PCI_n |
Error encountered in initializing PCI adapter. |
| Primary backplane is not present |
Faulty or improperly installed SCSI backplane board. |
| Processor n internal error |
Faulty microprocessor; faulty system board. |
| Processor bus parity error |
| Processor in socket 1 not installed! |
No microprocessor installed in primary microprocessor socket. |
| SCSI cable not present on connector A or B of the primary backplane |
SCSI cable is loose, improperly connected, or faulty. |
| Shutdown failure |
Shutdown test failure. |
| System backplane error |
Faulty or improperly installed SCSI backplane board. |
| System halted! Must power down |
Wrong password entered too many times. |
| Time-of-day clock stopped |
Faulty battery. |
| Time-of-day not set - please run SETUP program |
Incorrect Time or Date settings; faulty system battery. |
| Timer chip counter 2 failed |
Faulty system board. |
| Unsupported CPU combination |
Microprocessor(s) is not supported by the system. |
| Unsupported CPU stepping detected |
| Unsupported DIMM detected in the RAID DIMM slot! |
RAID memory module is not supported by the system. |
| Unsupported RAID key detected! |
RAID hardware key is not supported by the system. |
| Utility partition not available |
The <F10> key was pressed during POST, but no utility partition exists on the boot hard drive. |
| The VRM for the processor in socket n is not installed. |
Specified microprocessor VRM is faulty, unsupported, improperly installed, or missing. |
| Warning: Detected mode change from RAID to SCSI B of the embedded RAID subsystem. |
Type of controller has changed since previous system boot. |
| Warning: Detected missing RAID hardware for the embedded RAID subsystem. Data loss will occur! Press Y to switch mode to SCSI, press any other key to disable both channels. Press Y to confirm the change; press any other key to cancel. |
| Warning: Firmware is out-of-date, please update. |
Firmware error. |
| Warning! No microcode update loaded for processor X |
BIOS error. |
| Write fault |
Faulty diskette, CD/diskette drive assembly, hard drive, or hard-drive subsystem. |
| Write fault on selected drive |
Previous Next
