Dell PowerEdge 4600

System Board

Ports

The PowerEdge 4600 system board is equipped with the following ports:

Interface Ports Integrated Component Ports

Two (2) Serial Ports
Two (2) PS/2 Ports
One (1) USB with two (2) ports
One (1) Parallel Port

One (1) Intel Pro 10/100 Network Interface Card Port
One (1) BroadCom 10/100/1000BASE-T NIC Port
One (1) ATI Rage XL video port

Jumpers

The Dell PowerEdge 4600's system board features a jumper bank with settings for EMI reduction, the system password, and the system configuration settings. Click on the blue square within the picture below to see a close-up of the jumper bank.

This is a picture of the 4600's systemboard
This is a close-up of the 4600's jumper bank

Jumper Setting Description

SPREAD JUMPERED Enables spread-spectrum clocking for EMI reduction (do not change).

PASSWRD The password feature is enabled. (Default)

UNJUMPERED The password feature is disabled.

NVRAM_CLR The configuration settings are retained at system boot. (Default)

The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point where the system will not boot, install the jumper plug and boot the system. Remove the jumper before restoring the configuration information.)

RSVD UNJUMPERED Reserved (do not change).(Default)

Key

Jumpered

Unjumpered